58
Use this alternate installation method only
when the method found on page 54 does not
work with your vehicle Lap and Shoulder belts.
Place child in the carrier.
Position Infant Carrier on a rear vehicle seat,
with the foot end firmly against the back of the
vehicle seat.
Route only the vehicle lap belt through both
Belt Guides. BUCKLE THE BELT.
Lock your vehicle lap shoulder belt. The
shoulder belt should lie flat against the vehicle
seat back. Refer to your vehicle Owner's
Manual for how your vehicle lap and shoulder
belt locks.
In many vehicles, you can switch the shoulder
belt retractor into locking mode by pulling the
shoulder belt out all the way. In some vehicles
the buckle locks. Check the vehicle Owner’s
Manual to see how your system locks.
NEVER install this child restraint using a
non-locking vehicle lap shoulder belt.
INSTALLING INFANT CARRIER ONLY WITH A
LAP/SHOULDER BELT (ALTERNATE)
1
1
2
2
To Next Page
Loading...
Need help?
General
