52
Attaching Infant Carrier to Base
Make sure handle is locked in Position A (see page
20). ALWAYS verify that the handle is LOCKED in
Position A before lifting Infant Carrier by the handle.
An unlocked handle could move unexpectedly,
causing child to fall out.
Lift Infant Carrier by the Handle and drop the
Carrier into the base until an audible CLICK is
heard.
ALWAYS lift up on the carrier to check that it is
securely attached to base.
IMPORTANT: The window on the top of the load
leg will show green when the carrier is securely
attached to the base.
ALWAYS have the handle locked in Position A
while using this child restraint in a vehicle.
ALWAYS check to ensure that the Infant Carrier
is securely attached to the Base by pulling up
on the handle.
Extend the L.S.P ( Linear Side Impact Protection)
device. ( see page 65)
2
1
USING THE INFANT CARRIER WITH THE BASE
CLICK!
1
2
3
1
2
To release carrier,
Press and hold 1,
then Press 2
Para liberar el
portabebé, mantenga
presionado 1 y luego
presione 2
CY_171_3835_a
3
To Next Page
Loading...
Need help?
General
