40
BEFORE installing base, make sure
vehicle is on level ground. Place base
on an approved LATCH vehicle
seating location.
Remove LATCH anchors from storage.
Remove each connector by pulling the
red strap while pulling out.
Unfold the Load Leg from underneath
the Base.
Position Base on a rear vehicle seat. If
a hump is present on the floor of the
vehicle, see page 35 for important
information on the limits of using the
Load Leg in this seating position.
Adjust the Leveling Foot to achieve the
correct angle which allows the ball to
fall in the green zone as shown on the
Level Indicator. See page 39.
Front of vehicle
3
4
INSTALLING THE BASE USING LATCH
2
1
2
3
4
1
To Next Page
Loading...
