CYBEX gold ATON M - Securing the Base with Belt Lock-off

50
Press the Lock-o down until it locks into place.
If the Lock-o does not lock, try loosening the
vehicle belt slightly.
Grab the Base at the Belt Guides and pull from
side to side and front to back to make sure the
base is installed correctly. The Base should not
move more than 1 inch (2.5 cm) in any direction.
If the Base moves too much, open the Lock-o
and remove a little more slack from the vehicle
belt, close Lock-o and recheck. After this, if the
Base still moves too much, you may need to try
a dierent vehicle seat location or installation
method, or both.
Install load leg, see page 36.
7
8
INSTALLING THE BASE USING A LAP BELT ONLY
7
8
CLICK!