4. Tilt console assembly forward and insert USB stick into the internal USB port of the MCC board.
Do NOT insert USB stick into optional E3 View Monitor.
Qty.DescriptionItem
1Console assembly1
1MCC board2
5. Toggle power switch on (I).
Console damage may occur. Do NOT turn power off, press any keys, or
remove USB stick during this procedure.
The software will load into console. This procedure will take approximately 3 minutes. During this
time there will be beeping noises from the console. When upload is complete, the display will show
[re][bot].
6. Toggle power switch off (0).
7. Remove USB stick from internal USB port.
8. Install the four short screws and one long screw securing the front cover and iPad clip to the console
assembly using a Phillips screwdriver.
Qty.DescriptionItem
1Console assembly1
4Short screw2
1iPad clip3
1Long screw4
Complete update
1. Verify the power cord is not being pinched under the front of the treadmill.
2. Toggle power switch on (I).
3. Operate unit at all levels to verify proper operation.
Page 100 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
Need help?
General
