Run? or Are you there?
The message Run? (LED console) or Are you there? (E3 View Monitor) appears regularly.
Cause:
A motion sensor is not available on the 525T Treadmill and must be set to disabled.
Service:
See Line Frequency / IR Sensor in Setup options to disable the motion sensor.
Exit error log
Exit by pressing the STOP key to return to Dormant Mode.
Software Update 525T
Software can ONLY be installed on the model it is designed for. Do NOT install this software on other
Arc Trainers, Bikes, or Treadmills.
Tools Required
• USB stick (CP-23199)
• Phillips screwdriver
Repairs and Service
• DO NOT load zip files onto USB stick
• Load un-zipped files onto USB stick
• DO NOT remove USB stick during upload procedure
• Power must remain on during upload procedure
• DO NOT press any keys on console during upload procedure
Prepare USB stick
1. Plug USB stick into PC.
2. Delete any files on USB stick.
Verify USB stick is blank.
3.
Go to the LF World service product pages for the latest software files or contact Cybex Customer
Service at 508-533-4300 to receive via email.
Page 98 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
Need help?
General
