CYBEX 525T Service Manual

Loosen rear roller
Loosen the rear roller mounting bolts using a 3/4” Socket wrench.
Remove front roller
1.
Moving parts hazard. To avoid serious injury slowly release tension to
parts.
Loosen the left mounting bolt using a 9/16” Socket wrench.
Qty.DescriptionItem
1Front roller1
1Drive belt2
1Tensioning slot3
1Mounting bolt4
2. Loosen the right mounting bolt using a 9/16” Socket wrench.
3. Remove the front roller and slide the drive belt off of the front roller.
Remove drive belt
Remove the drive belt off of the drive motor pulley.
Install drive belt
Install the drive belt into the grooves on the drive motor pulley.
Install front roller
1. Slide the front roller into the running belt.
2. Slide the drive belt around the front roller before attaching the front roller.
Qty.DescriptionItem
1Front roller1
1Drive belt2
1Tensioning slot3
1Mounting bolt4
Page 147 of 199
Cybex 525T Treadmill Part Number

CYBEX 525T Specifications

General

Brand	CYBEX
Model	525T
Category	Treadmill
Language	English