2. Install the nine screws securing the E3 View Monitor to the console using a Phillips screwdriver.
Qty.DescriptionItem
1Console Assembly1
1E3 View Monitor2
9Screw3
1Ground wire screw4
3. Install the ground cable to the E3 View monitor using an 11/32” nut driver.
4. Screw the A/V and coax cables into the E3 View monitor.
Qty.DescriptionItem
1Control board cable1
1A/V cable2
1Coax cable3
5. Plug IR receiver cable into E3 View Monitor.
Install back cover
Install the four screws securing the back cover to the console assembly using a Phillips screwdriver.
Page 186 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
