MCC board cables
Qty.DescriptionItem
1MYE/BV, Gray1
1CSAFE, Red2
1Console cable3
1Upper display4
1Headphone jack5
1iPod (optional)6
1Heart rate7
1Handset membrane8
1
iPod board assembly (option-
al)
9
1E-stop switch10
3. Unplug optional iPod cable.
The iPod cable is held in place by a notch in the access cover.
a) Press in both side latches of cable connector.
b) Ensure latches disengage from the connector.
c) Unplug cable by holding down latches on both sides and pulling straight out from connector.
Do not pull on wires, remove by connector.
Remove MCC board
Remove the four screws securing the MCC board to the bezel using a Phillips screwdriver.
Page 189 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
