4.
Press Up or Down to scroll through and verify all TV channels.
If all TV transmitters are stored, and they all correlate the TV number to the correct TV heard, setup
is complete. If not you may need to re-scan or adjust the transmitter codes (see documentation for
your transmitters to perform a code change).
5. Press STOP to exit setup. Transmitter setup complete.
Adjust sound volumes
After completing setup, the sound volume should be adjusted between all TV’s.
1. Plug headphones into headphone jack.
2.
Press Up or Down to select a TV station.
3. Adjust the volume of each TV to match each other using the TV’s remote control.
The goal is for a volume setting of 10 on the unit to be the same for all TV's.
4. Repeat procedure for all TV’s.
Using the Cybex Wireless Audio Receiver
1. Plug headphones into headphone jack.
2.
Press Up or Down to select TV channels.
3.
Press volume Up or Down to adjust volume.
Setup Complete
Personal TV Setup
The personal TV configuration uses a TV on a stand in front of the equipment.
Page 35 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
Need help?
General
