3.
Navigate through the setup menu with the UP and DOWN keys.
4. Navigate to the A/V option.
5.
Press the ENTER key once to enter setup values.
6. Select C.A.B. (Console Adapter Box) or C-tu (Connected TV) from the A/V options.
7.
Press the ENTER key again to save any changes and advance forward in the menu.
8. Press the STOP key to exit Setup options.
Adjust volume
1. Plug headphones into headphone jack.
2. Listen to the TV audio. At the default volume level of 10 on the unit, the TV volume should be ‘normal’.
3. If the TV is too loud or too quiet, adjust the TV volume using the Broadcast Vision Remote Control
or controls on the TV until it is acceptable.
4. Adjust the volume on the unit using the Volume Up/Down buttons to ensure a normal range for use.
Once the TV volume is set, apply this TV volume level to all TV’s.
Setup Complete
Embedded TV Setup
The embedded TV configuration uses the E3 View Monitor in the console of the product.
Determine TV’s signal source
For traditional RF Cable Signal over Coax, or a distributed/modulated club setup over Coax, connect
the coax at the base of the unit. Skip to E3 View Monitor Setup.
For installations using a Set Top Box (Cable Box, Satellite Box or IPTV Box) for each unit, determine
the output from the Set Top Box. Follow Set Top Box Setup procedure.
• Coax - Connect the included coax jumper at the base of the unit. Set the A/V mode to STB+Tuner.
Page 37 of 199
Cybex 525T Treadmill Part Number
To Next Page
Loading...
Need help?
General
