Cybex 750T Treadmill Service Manual
Safety
Page 1-3
Keep the running belt clean and dry at all times.•
DO NOT • leave the treadmill unattended when plugged in and running. NOTE: Before leaving the
treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then, turn
all controls to the STOP or OFF position and remove the plug from the outlet. Remove the e-stop key
from the treadmill.
Immobilize the treadmill (when not in use) by removing the e-stop key.•
Inspect the treadmill for worn or loose components before each use. Do not use until worn or damaged •
parts are replaced.
Maintain and replace worn parts regularly. Refer to “Preventive Maintenance” section of Owner’s •
Manual.
DO NOT• operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly or
(3) if the treadmill has been dropped or damaged. Seek service from a qualifi ed technician.
DO NOT • place the cord near heated surfaces or sharp edges.
DO NOT • use the treadmill outdoors.
DO NOT • operate the treadmill around or where aerosol (spray) or where oxygen products are being
used.
Read and understand the Owner’s Manual completely before using the treadmill.•
Ensure all users wear proper footwear on or around all Cybex equipment.•
Set up and operate the treadmill on a solid, level surface. Do not operate in recessed areas or on •
plush carpet.
Provide the following clearances: 19.7 inches (0.5 m) at each side, 79 inches (2.0 m) at the back and •
enough room for safe access and passage at the front of the treadmill. Be sure your treadmill is clear
of walls, equipment and other hard surfaces.
DO NOT• attempt repairs, electrical or mechanical. Seek qualifi ed repair personnel when servicing. If
you live in the USA, contact Cybex Customer Service at 888-462-9239. If you live outside the USA,
contact Cybex Customer Service at 508-533-4300.
Use Cybex factory parts when replacing parts on the treadmill.•
DO NOT • modify the treadmill in any way.
DO NOT • use attachments unless recommended for the treadmill by Cybex.
Ensure all User and Facility Safety Precautions are observed.•
To Next Page
Loading...
Need help?
General
