Install top steps
1. Install right top step by placing in position and inserting a long 3/8” drive socket extension into top
step.
Qty.DescriptionItem
1
3/8” Drive Socket Exten-
sion
1
1Right Top Step2
2. Pry the long 3/8” drive socket extension forwards to secure right top step.
3. Repeat steps 1 and 2 for left top step.
Install end caps
1. Install two screws securing right end cap using a Phillips screwdriver.
Qty.DescriptionItem
2Screws1
1Right end cap2
2. Repeat step for left end cap.
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Page 125 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
