CYBEX 770T - Page 212

2. Remove the six screws securing the fan and duct to the console assembly using a Phillips screwdriver.
Qty.DescriptionItem
1Console Assembly1
1Louver2
1Duct3
6Screw4
1Fan5
The louver is held in place by the duct.
Remove Cybex GO monitor cables
1. Unplug the power, ethernet cable, and control board cable from the Cybex GO monitor.
Qty.DescriptionItem
1Power cable1
1Cat6 ethernet cable2
1Coax cable3
1Control board cable4
2. Unscrew the coax cable from the Cybex GO monitor.
3. Remove the ground cable from the Cybex GO monitor using an 11/32” nut driver.
Page 212 of 261
Cybex 770T/790T Treadmill Part Number