CYBEX 770T - Page 229

7. Install USB cover to two support brackets using two screws and a Phillips screwdriver.
Qty.DescriptionItem
2Screw1
1USB cover2
2Support bracket3
8. Plug USB cable and graphics board cable into CardioTouch screen.
Qty.DescriptionItem
1CardioTouch screen1
1USB board2
1USB cable3
2Thumb control cables4
1Membrane cable5
1Graphics board cable6
Install handset assembly
1. Place handset assembly in position and plug in the following cables: graphics board (J12), handset
membrane (J9), contact heart rate grips (J7) and the ground wire.
Qty.DescriptionItem
1MCC board1
1Graphics board (J12)2
1Handset membrane (J9)3
1Contact heart rate grips (J7)4
Page 229 of 261
Cybex 770T/790T Treadmill Part Number