3. Unplug cables from MCC board by un-latching connectors with the following procedure:
a) Press in the top of the cable connector.
Qty.DescriptionItem
1
DO NOT PULL CONNEC-
TOR OUT BY THE WIRES!
1
1Step a, Latch2
1Step b3
1Step c4
b) Ensure latch disengages the connector.
c) Unplug cable by holding down latch and pulling straight out from connector. Do not pull on wires,
remove by connector.
4. Carefully lift handset assembly and unplug the following cables: graphics board (J12), handset
membrane (J9), contact heart rate grips (J7) and the ground wire (located under the MCC board).
Qty.DescriptionItem
1MCC board1
1Graphics board (J12)2
1Handset membrane (J9)3
1Contact heart rate grips (J7)4
Page 249 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
