Install handset assembly
1. Place handset assembly in position and plug in the following cables: graphics board (J12), handset
membrane (J9), contact heart rate grips (J7) and the ground wire.
Qty.DescriptionItem
1MCC board1
1Graphics board (J12)2
1Handset membrane (J9)3
1Contact heart rate grips (J7)4
2. Route iPod cable through notch in access cover.
3. Install eight screws securing handset assembly to console using a Phillips screwdriver.
Qty.DescriptionItem
1Handset assembly1
1Console2
8Screw3
Complete installation
1. Plug the power cord into the power outlet.
2. Verify the power cord is not being pinched under the front of the treadmill.
3. Operate the unit at all levels to verify proper operation.
Wireless Audio Receiver Module
Tools Required:
• Phillips screwdriver
• ESD (Electrostatic Discharge) grounding strap
Parts required to install Wireless Audio Receiver Module.
Page 251 of 261
Cybex 770T/790T Treadmill Part Number
To Next Page
Loading...
