CYBEX 770T - Install Power Supply

Install power supply
1. Install the power supply to the base using clamp and screw.
Qty.Description
1AC Cord1
1Power Supply Inlet2
1Clamp3
1Gray Cable Clip4
1Screw5
1
Console Cable DIN
Connector
6
1Power Supply Output7
2. Plug the AC cord into the power supply inlet.
3. Route console cable through the gray cable clip.
4. Connect the console cable's DIN connector to the power supply output. Make sure the two connectors
snap firmly together and can not be pulled apart without pulling the sleeve back to release it.
Install optional A/V or CSAFE cables
1. Insert the CSAFE coupler into the mounting plate by hooking the lower tab into the mounting plate
and snapping in the upper tab.
Qty.Description
1Upper tab1
1Mounting plate2
1CSAFE coupler3
1Lower tab4
1Installed5
1Front of unit6
Page 25 of 105
Cybex Treadmill Product Number 770T Part Number LT-22983-4 M