26
• Always fold out the load leg (4) until it locks.
• Release the lock of the ISOFIX connectors (5). Both locks
can be adjusted independently. Push both buttons
(6) and (7) simultaneously and pull the ISOFIX connectors
out of the base to the endstopper.
• The ISOFIX connectors (5) have to lock into the ISOFIX
anchorage points (2) with an audible click.
• Make sure that the seat stays firmly in place by trying to pull
it out of the ISOFIX connect guides.
• The green safety indicator (8) must be clearly visible on
both ISOFIX release buttons.
• Next, push the base in the direction to the backrest until it is
fully aligned with the backrest.
6
7
2
5
6
7
8
4
NOTE! Moving the base sideways will further brace the base
with the backrest.
NOTE! There will be a charateristic warning signal audible
till the base is installed correctly (see chapter: „ADJUSTING
THE LOAD LEG“).
NOTE! If the load leg is folded out and the transportation
lock is removed and there is no noise, you have to change the
battery (see chapter: „HOW TO CHANGE BATTERY“).
To Next Page
Loading...
Need help?
General
