2 SAFETY AND INSTALLATION PRECAUTIONS
WARNINGS AND SYMBOLS 2.2
Safety instructions and warnings are marked in this manual by the following pictograms:
CAUTION
Special data, restrictions and rules with regard to preventing damage.
WARNING
A WARNING refers to possible injury to the user or significant material damage to the COI if the user
does not (carefully) follow the procedures.
A procedure, circumstance, etc, which deserves extra attention.
USE FOR INTENDED PURPOSE 2.3
1. The COI is constructed as per the applicable safety-technical guidelines.
2. Use the COI only:
In technically correct conditions
In a closed space, protected against rain, moisture, dust and condensation
Observing the instructions in the installation manual
WARNING Never use the COI in locations where there is danger of gas or dust explosion or
potentially flammable products!
3. Use of the COI other than mentioned in point 2 is not considered to be consistent with the intended purpose.
BEP Marine is not liable for any damage resulting from the above.
ORGANIZATIONAL MEASURES 2.4
The user must always:
Have access to the user's manual and be familiar with the contents of this manual
MAINTENANCE AND REPAIR 2.5
Switch off supply to the system
Be sure that third parties cannot reverse the measures taken
If maintenance and repairs are required, only use original spare parts
GENERAL SAFETY AND INSTALLATION PRECAUTIONS 2.6
Connection and protection must be done in accordance with local standards
Do not work on the COI or system if it is still connected to a power source. Only allow changes in your
electrical system tobe carried out by qualified electricians
Check the wiring at least once a year. Defects such as loose connections, burned cables, etc. must be
corrected immediately
To Next Page
Loading...
