D-Link AC750 - Advanced; Virtual Server

72D-Link DIR-818LW User Manual
Section 3 - Conguration
This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Enter a Name for the rule or select an Application name
from the drop-down menu. Select an Application name
and click << to populate the Name eld.
Enter the IP Address of the computer on your local
network that you want to allow the incoming service to.
If your computer is receiving an IP address automatically
from the router (DHCP), your computer will be listed
in the Computer Name drop-down menu. Select your
Computer Name and click <<.
Enter the port that you want to open next to Private Port
and Public Port. The private and public ports are usually
the same. The public port is the port seen from the Internet
side, and the private port is the port being used by the
application on the computer within your local network.
Select TCP, UDP, or Both from the drop-down menu.
Select the schedule of time when the Virtual Server Rule
will be enabled. The schedule may be set to Always, which
will allow this service to always be enabled. You can create
your own schedules in the Tools > Schedules section.
Select Allow All (most common) or a created Inbound
lter. You may create your own inbound lters from the
Advanced > Inbound Filter page.
Click on Save Settings.
Name:
IP Address:
Private Port/
Public Port:
Protocol:
Schedule:
Inbound Filter:
Virtual Server
Advanced