D-Link AC750 - Network (MAC) Filters

77D-Link DIR-818LW User Manual
Section 3 - Conguration
Network (MAC) Filters
Select Turn MAC Filtering OFF, Turn MAC Filtering ON and
ALLOW computers listed to access the network, or Turn
MAC Filtering ON and DENY computers listed to access the
network from the drop-down menu.
Enter the MAC Address of the computer you would like to
lter, or select a Computer Name from the drop-down menu
and click <<. Use the check box on the left to either enable or
disable the entry.
Note: To nd the MAC address on a computer, please refer to the
Networking Basics section in this manual.
Computers that have obtained an IP address from the router’s
DHCP server will be in the DHCP Client List.
The schedule may be set to Always, which will allow this
service to always be enabled. If you created a pre-dened
schedule, you can select it from the drop-down menu, or click
on New Schedule to add one.
Click Save Settings.
Congure MAC
Filtering:
MAC Address:
DHCP Client
List:
Schedule:
Use MAC (Media Access Control) Filters to control access to LAN (Local Area Network) computers by using their MAC addresses.
You can create a list of MAC addresses and then choose to either deny them access or allow them access to your network.