D-Link AC750 - Port Forwarding

73D-Link DIR-818LW User Manual
Section 3 - Conguration
This will allow you to open a single port or a range of ports.
Port Forwarding
Enter a Name for the rule or select an Application Name
from the drop-down menu. Select an Application Name
and click << to populate the Name eld.
Enter the IP Address of the computer on your local
network that you want to allow the incoming service to.
If your computer is receiving an IP address automatically
from the router (DHCP), your computer will be listed
in the Computer Name drop-down menu. Select your
Computer Name and click <<.
Enter the TCP and/or UDP port or ports that you want
to open. You can enter a single port or a range of ports.
Separate ports with a comma.
Example: 24,1009,3000-4000
Select the schedule of time when the Virtual Server Rule
will be enabled. The schedule may be set to Always, which
will allow this service to always be enabled. You can create
your own schedules from the Tools > Schedules section.
Select Allow All (most common) or a created Inbound
filter. You may create your own inbound filters in the
Advanced > Inbound Filter page.
Click on Save Settings.
Name:
IP Address:
Ports to Open
TCP/UDP:
Schedule:
Inbound Filter: