D-Link AC750 - Ipv6 Firewall

92D-Link DIR-818LW User Manual
Section 3 - Conguration
IPv6 Firewall
The DIR-818LW’s IPv6 Firewall feature allows you to congure which kind of IPv6 trac is allowed to pass through the device.
The IPv6 Firewall functions in a similar way to the IP Filters feature.
Check the box to Enable the IPv6 rewall simple security.
From the drop-down menu, select Turn IPv6 Filtering OFF, Turn
IPv6 Filtering ON and Allow rules listed, or Turn IPv6 Filtering
ON and Deny rules listed.
Enter a Name to identify the IPv6 rewall rule.
The schedule may be set to Always, allowing this service to always
be enabled. Or select a schedule from the drop-down menu for
enabling the IPv6 Firewall Rule. You can create your own schedule
in the Tools > Schedules section.
Use the Interface drop-down menu to specify the interface that
connects to the source IPv6 addresses of the rewall rule.
Enter the source IPv6 address range in the adjacent IP Address
Range eld.
Select the protocol of the rewall port (All, TCP, UDP, or ICMP).
Use the Interface drop-down menu to specify the interface that
connects to the destination IP addresses of the rewall rule.
Enter the destination IPv6 address range in the adjacent IP Address
Range eld.
Enter the rst port of the range that will be used for the rewall rule
in the rst box and enter the last port in the range in the second box.
Click Save Settings.
Enable IPv6
Simple Security:
Congure IPv6
Filtering below:
Name:
Schedule:
Source:
IP Address Range:
Protocol:
Dest:
IP Address Range:
Port Range: