86D-Link DIR-818LW User Manual
Section 3 - Conguration
Enter a Name for your data route. Use the check box on
the left to either enable or disable the route.
Enter the IP address of packets that will take this route.
Enter the Netmask of the route, please note that the octets
must match your destination IP address.
Enter your next hop Gateway to be taken if this route is
used.
The route Metric is a value from 1 to 15 that indicates the
cost of using this route. A value 1 is the lowest cost and
15 is the highest cost.
From the drop-down menu, select the Interface that the
IP packet must use to transit out of the router when this
route is used.
Click Save Settings.
Name:
Destination IP:
Netmask:
Gateway:
Metric:
Interface:
Routing
The Routing option is an advanced method of customizing specic routes of data through your network.
To Next Page
Loading...
