D-Link DAP-1160

18D-Link DAP-1160 User Manual
Section 2 - Conguration
WAN Settings
WAN Settings are only used with WISP Client Router wireless mode and WISP Repeater wireless mode. Choose Dynamic IP(DHCP) to
obtain IP Address information automatically from your ISP. Select this option if your ISP does not give you any IP numbers to use. This
option is commonly used for Cable modem services.
Dynamic IP (DHCP)
The Host Name is optional but may be required by
some ISPs.
Host Name:
You may need to change the MTU
(Maximum Transmission Unit) for optimal
performance with your specific ISP. The
default MTU size is 1500.
MTU Size:
Select this option if you want the DAP-1160
to get the DNS (Domain Name System)
server IP address automatically.
Attain DNS
automatically:
Select this option if you want to manually
enter the DNS Server IP address(es).
Fields to enter the Primary and Secondary
DNS server IP addresses will appear after
you select this option.
Set DNS
manually:
Enter the Primary DNS server IP address assigned by your ISP.
Primary DNS
Server:
This is optional.
Secondary DNS
Server:
The default MAC address is set to the MAC address on the AP (Access Point). You can click the Clone Your
PC's MAC Address button to replace the AP's MAC address with the MAC address of your Ethernet card. It is not
recommended that you change the default MAC address unless required by your ISP.
Clone MAC
address: