D-Link DAP-1320 User Manual

24D-Link DAP-1320 User Manual
Section 3 - Conguration
Wi-Fi Settings
This is set to Repeater mode and cannot be changed.
Click Scan to use Site Survey to display available wireless
networks within range of the DAP-1320. Select the one you
want to extend. You can also type in the name (SSID) of the
wireless network. The SSID is case-sensitive and must be
entered exactly the same as your router or access point.
Select the security method that is being used by the wireless
network that you have selected: WEP, WPA/WPA2, or None.
If you selected WEP or WPA/WPA2, you will be required to
enter the password or security key for the network you are
attempting to join.
Click Save to save the settings and return to the home page.
Wireless Mode:
Wi-Fi Network
Name (SSID):
Security:
Password:
Save:
From the Home page, click on the Settings drop-down menu at the top of the page and select Wi-Fi. Here you can congure
the Wi-Fi Network you would like your DAP-1320 to connect to. Use Site Survey to scan available Wi-Fi networks so you can
select the one you would like to extend.

D-Link DAP-1320 Specifications

Wireless Standards and Antennas

wireless standards	IEEE 802.11n, IEEE 802.11g
antenna type	2 Internal Antennas

Weight and Dimensions

dimensions	1.89” x 1.65” x 2.11” (4.8 x 4.19 x 5.36 cm)
weight	0.152 lb (68.94g)