DAP-1610 AC1200 Wi-Fi Range Extender
User Manual
Configuring via Web-based Interface
Firmware Update
On the System / Firmware Update page, you can update the firmware of the extender and
configure the automatic check for updates of the extender's firmware.
!
Update the firmware only when the extender is connected to your PC via a wired
connection.
Figure 59. The System / Firmware Update page.
The current version of the extender's firmware is displayed in the Current firmware version
field.
By default, the automatic check for the extender's firmware updates is enabled. If a firmware update
is available, a notification will be displayed in the top right corner of the page.
To disable the automatic check for firmware updates, in the Remote update section, move the
Check for updates automatically switch to the left and click the APPLY SETTINGS button.
To enable the automatic check for firmware updates, in the Remote update section, move the
Check for updates automatically switch to the right and click the APPLY SETTINGS button.
By default, in the Remote server URL field, the D-Link update server address
(fwupdate.dlink.ru) is specified.
You can update the firmware of the extender locally (from the hard drive of your PC) or remotely
(from the update server).
Page 76 of 91
To Next Page
Loading...
