D-Link DAP-2695 - WDS with AP Mode

802.11 b/g /n Access Point Command Line Interface Manual
13
get assoclimitstatus
Display Association Limit setting status
get assoclimitstatus
get mcastrate
Display mcast rate
get mcastrate
get wlancount
Display wlan count
get wlancount
get wlan_utilization
Get Wlan utilization
get wlan_utilization
get d-wepkeylen
Display 802.1X dynamic WEP Key Length
get d-wepkeylen
get d-wepkeyupdate
Display 802.1X dynamic WEP Rekey Interval(in Secs)
get d-wepkeyupdate
Set Command:
Function
Syntax
set apmode
Set AP Operate Mode
set apmode [ap/apc/wdsap/wds]
config wlan
Set AP Band (0:2.4G/1:5G)
config wlan [0/1]
set band
Set ap band (2.4G or 5G)
set band [2.4g/5g]
set ssid
Set Service Set ID
set ssid
set ssidhidden
Set ssidhidden
set ssidhidden
set autoChannel
Set AutoChannel
set autoChannel
set channel
Set Channel (1--11)
set channel
set cwm
Set CWM
set cwm
set wireless
Set Wireless
set wireless
set wlmode_db
Set Wlmode
set wlmode_db
set beaconinterval
Set Beaconinterval (range:25--500)
set beaconinterval [25-500]
set dtim
Set DTIM (1--15)
set dtim [1-15]
set txpower
Set Txpower
set txpower
set wmm
Set WMM
set wmm
set acktimeout_a
Set acktimeput in A band (range:25--200)
set acktimeout_a
set acktimeout_g
Set acktimeput in G band (range:48--200)
set acktimeout_g [48-200]
set shortgi
Set Shortgi
set shortgi
set igmpsnoop
Set igmp snooping states
set igmpsnoop [enable/disable]
set assoclimit
Set Association Limit
set assoclimit [enable/disable/number]
set mcastrate
Set mcast rate
set mcastrate