D-Link DAP-3711 - Configuring the Second DAP-3711 in Client Mode

11D-Link DAP-3711 User Manual
Section 2 - Installation
4. Log in to the administration user interface.
The default login information is:
Username: admin
Password: admin
5. Follow the Setup Wizard’s instructions to congure the device in Access Point Mode.
Conguring the Second DAP-3711 in Client Mode
1. Follow steps 1-4 of the instructions above to power on the device. Launch the Setup Wizard to congure the device in Client
Mode.
2. To a void an IP address conict, change the IPv4 address so that it is dierent from the rst DAP-3711’s IP address (for instance,
by changing it to 192.168.0.51, as in the following screenshot).