D-Link DCH-M225 - Configure WPA;WPA2 Security

34D-Link DCH-M225 User Manual
Section 3 - Conguration
Conguring WPA/WPA2 Personal
If you did not enable wireless security during initial setup, it is recommended that you do so using the web-based conguration
utility. Establish wireless connectivity before enabling wireless security. For more information about security, refer to “Wireless
Security Options” on page 54. If you prefer WPS, proceed to “Connecting to Wireless Clients Using WPS” on page 36.
2. Simply click Log In. (The Admin Password is blank by default.)
Note: If you did not create a password, it should be left blank.
1. Log into the web-based conguration by opening a web browser
and entering http://dlinkap.local./.
3. The conguration interface will open to the Home page. Click on
the Settings drop-down menu and select Wi-Fi. Then congure
the Wi-Fi network you would like your DCH-M225 to connect to.