5 Command Line Interface D-Link Web Smart Switch User Manual
To test the connectivity between network devices.
The ping command checks if another IP address is reachable on
the network. You can ping the IP address connected to through
the managed VLAN (VLAN 1 by default), as long as there is a
physical path between the switch and the target IP equipment. By
default, Switch sends five pings to the target IP.
<ipaddr> - The IP address of the host.
Example usage:
To ping the IP address 10.90.90.91:
DGS-1210-28> ping 10.90.90.91
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
Reply Received From :10.90.90.91, TimeTaken : 20 msecs
--- 10.90.90.91 Ping Statistics ---
3 Packets Transmitted, 3 Packets Received, 0% Packets Loss
DGS-1210-28>
To test the connectivity between network devices.
The pingv6 command checks if another IP address is reachable
on the network. You can ping the IP address connected to
through the managed VLAN (VLAN 1 by default), as long as
there is a physical path between the switch and the target IP
equipment. By default, Switch sends five pings to the target IP.
<ipv6addr> - The IPv6 address of the host.
Example usage:
To ping the IP address 3000::1:
DGS-1210-28> ping6 3000 ::1
Reply Received From : 3000 ::1, TimeTaken : 20 msecs
Reply Received From : 3000 ::1, TimeTaken : 20 msecs
Reply Received From : 3000 ::1, TimeTaken : 20 msecs
--- 3000 ::1 Ping Statistics ---
3 Packets Transmitted, 3 Packets Received, 0% Packets Loss
DGS-1210-28>
To Next Page
Loading...
