D-Link DGS-1210-10 - Show Ipif; Show Switch

5 Command Line Interface D-Link Web Smart Switch User Manual
100
DGS-1210-28> reset config
% Device will reboot after reset configuration successfully.
DGS-1210-28>
show ipif
Purpose
To display the configuration of an IP interface on the Switch.
Syntax
show ipif
Description
The show ipif command displays the current IP address of the
switch.
Parameters
None.
Restrictions
None.
Example usage:
To display IP interface settings:
DGS-1210-28> show ipif
IP Setting Mode : Static
IP Address : 10.90.90.90
Subnet Mask : 255.0.0.0
Default Gateway : 0.0.0.0
DHCPv6 Client State : Disabled
IPv6 Global Unicast Address: 3ffe:501:ffff:100:100::1/64
DGS-1210-28>
show switch
Purpose
To display information about the Switch.
Syntax
show switch
Description
The show switch command displays the status of the switch.
Parameters
None.
Restrictions
None.
Example usage:
To display the switch information: