IPv4 Access-List: Add the specified ports in the IPv4 access list group.
IPv6 Access-List: Add the specified ports in the IPv6 access list group.
Click Apply to make the configurations take effects.
ACL > ACL Hardware Resource Status
The ACL Hardware Resource Status page displays the information of ACL Hardware Resource status.
Figure 4.113 - ACL > ACL Hardware Resource Status
PoE > PoE Global Settings (DGS-1210-10P/28P/52P/52MP only)
This page will display the PoE status including System Budget Power, Support Total Power, Remainder
Power, and The ratio of system power supply.
Figure 4.114 – PoE > PoE Global Setting
System Power Threshold: Manually configure the system power budget.
Power Shut Off Sequence: Defines the method used to deny power to a port once the threshold is reached.
The possible fields are:
Deny next port: When the power budget is exceeded, the next port attempting to power up is
denied, regardless of the port priority.
Deny low priority port: The port with the lower priority will be shut down to allow the higher priority
port to power up.
Click Apply to make the configurations take effects.
System Power Status: Displays the system power status of device.
Total PoE Power Budget: Displays the total PoE power budget of this switch.
Power Used: Displays the current used power of the switch.
Power Left: Displays the spare power of the switch.
The percentage of system power supplied: Displays the percentage of system power supplied of
the switch.
PoE > PoE Port Settings (DGS-1210-10P/28P/52P/52MP only)
The DGS-1210 PoE series supports Power over Ethernet (PoE) as defined by the IEEE specification. The
PoE port specification are listed in the table below:
To Next Page
Loading...
