D-Link DGS-1210-10 - Page 88

4 Configuration D-Link Web Smart Switch User Manual
82
Model Name
PoE Capable Ports
Power Budget
DGS-1210-10P
Port 1 ~ Port 8: Max. PoE Output 30 Watts
78 Watts
DGS-1210-28P
Port 1 ~ Port 4: Max. PoE Output 30 Watts
Port 5 ~ Port 24: Max. PoE Output 15.4 Watts
193 Watts
DGS-1210-52P
Port 1 ~ Port 8: Max. PoE Output 30 Watts
Port 9 ~ Port 24: Max. PoE Output 15.4 Watts
193 Watts
DGS-1210-52MP
Port 1 ~ Port 8: Max. PoE Output 30 Watts
Port 9 ~ Port 48: Max. PoE Output 15.4 Watts
370 Watts
The DGS-1210 PoE series work with all D-Link 802.3af or 802.3at capable devices. The Switch also works in
PoE mode with all non-802.3af capable D-Link AP, IP Cam and IP phone equipment via the PoE splitter
DWL-P50.
IEEE 802.3at defined that the PSE provides power according to the following classification:
Class
Usage
Output power limit by PSE
0
Default
15.4W
1
Optional
4.0W
2
Optional
7.0W
3
Optional
15.4W
4
Reserved
30W
The PoE port table will display the PoE status including, Port Enable, Power Limit, Power (W), Voltage (V),
Current (mA), Classification, Port Status. You can select From Port / To Port to control the PoE functions of
a port. The DGS-1210 PoE series will auto disable the ports if port current is over 375mA in 802.3af mode or
625mA in pre-802.3at mode.
Note: The PoE Status information of Power
current, Power Voltage, and Current is the power
usage information of the connected PD; please
"Refresh" to renew the information.