D-Link DGS-1210-10 - Reboot; Reset Config

5 Command Line Interface D-Link Web Smart Switch User Manual
9
9
9
9
Syntax
show iproute {<ipaddr> | static}
Description
The show iproute command will display the Switch’s current IP
routing table.
Parameters
<ipaddr> - Enter the IP address used here.
static – Specifies to display all the static routes.
Restrictions
None.
Example usage:
To display the contents of the IP routing table:
DGS-1210-28> show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Hops Protocol
---------------------------- --------------- -------------- --------- ---------------
Total Entries :0
DGS-1210-28>
reboot
Purpose
To reboot the Switch. If the Switch is a member of a stack, it may
be rebooted individually, without affecting the other members of
the stack.
Syntax
reboot
Description
The reboot command reboots the system. All network
connections are terminated and the boot code executes.
Parameters
None.
Restrictions
None.
Example usage:
To restart the Switch:
DGS-1210-28> reboot
% Device will reboot, please wait a few minutes to re-login.
DGS-1210-28>
reset config
Purpose
To reset the Switch to the factory default settings.
Syntax
reset config
Description
All configurations will be reset to the default settings.
Parameters
None.
Restrictions
None.
Example usage:
To restore all of the Switch’s parameters to their default values: