Figure 4.101 - Add Access Rule – IPv4 IGMP
IGMP Type (0-255): Sets the IGMP Type field as an essential field to match.
Click Next button then the ACL profile is added.
To define the IPv4 ACL TCP Rule: Select IPv4 ACL with TCP and click Next button. The updates to show
the follows:
Figure 4.102 - Add Access Rule – IPv4 TCP
IPv4 Address: Defines the range of source Ports relevant to the ACL rules.
Source: Defines the range of source Ports relevant to the ACL rules. For example, to set 0 – 15, set mask of
FFF0.
Destination: Defines the range of destination IP addresses, relevant to the ACL rules. For example, to set
0 – 15, set mask of FFF0.
To Next Page
Loading...
