When installing the Switch on a level surface, attach the rubber feet to the
bottom of each device. The rubber feet cushion the hub and protect the hub
case from scratching.
Figure 1. Attach the adhesive rubber pads to the bottom
Rack Mounting
The Switch can be mounted in an EIA standard-size, 19-inch rack, which can
be placed in a wiring closet with other equipment. Attach the mounting
brackets at the Switch’s front panel (one on each side), and secure them with
the provided screws.
Figure 2. Combine the Switch with the provided screws
Then, use screws provided with the equipment rack to mount each Switch in
the rack.
7
To Next Page
Loading...
Need help?
General