DIR-882 AC2600 Wave 2 MU-MIMO Wi-Fi Gigabit Router with
3G/LTE Support and 2 USB Ports
User Manual
Configuring via Web-based Interface
Figure 189. The page for adding an authorization server. The UAM section.
In the UAM section, you can specify the following parameters:
Parameter Description
Enable CHAP
authentication
Move the switch to the right to enable CHAP authentication.
Move the switch to the left to enable PAP authentication (the value
of this parameter is specified in the RADIUS server settings).
Authorization port
The number of a router port which will be used for UAM server
authorization. By default, the value 3990 is specified.
UAM server
Specify the URL of the UAM server which ensures client
authorization. The address of the UAM server should start with a
protocol. Example: http://dlink.ru
Access for
unauthorized users
Specify the list of resources (separated by a comma) which
unauthorized users are allowed to access. Please specify a site
address and a port. Example: dlink.ru:80
UAM encryption key Specify the UAM authentication encryption key.
After specifying the needed parameters, click the APPLY button.
After adding an authorization server, on the Advanced / CoovaChilli page, in the Status
section, the current state of the server connection is displayed.
To edit the parameters of a server, left-click the relevant line in the table. On the opened page,
change the needed parameters and click the APPLY button.
To remove a server, select the checkbox located to the left of the relevant line in the table and click
the DELETE button ( ).
Page 242 of 303
To Next Page
Loading...
