D-Link DNS-323

12D-Link DNS-323 User Manual
Section 3 - Configuration
Configuration
When rst powered on, during the initial boot sequence, the DNS-323 will wait to be assigned an IP address via DHCP.
If it does not receive an assigned IP address, by default it will have a self-assigned IP address of 192.168.0.32. It is
recommended to use the included D-Link Easy Search Utility when accessing and conguring the DNS-323 for the
rst time. If you want to change the IP address before logging in or are unable to connect to the DNS-323 IP address,
you can use the Easy Search Utility provided on the product CD to locate the device on your network and make any
needed changes.
The Easy Search Utility displays all available DNS-323 devices
on the network here.
Refresh the device list.
Click Conguration to access the Web-based utility of the
DNS-323.
Click Language if you wish to store non-English character les.
Refer to page 96.
Congure the LAN Settings for the DNS-323 here.
Click Apply to save and activate the changes to the LAN
Settings.
Volumes available for mapping are displayed here.
Choose an available drive letter. Click Connect to map the
selected volume. Click Disconnect to disconnect the selected
mapped volume.
Click Exit to close the utility.
Click to see the basic rmware and copyright information about
D-Link Easy Search Utility.
Network Storage
Device
Refresh
Configuration
Language
LAN
Apply
Drive Mapping
Available Drive
Letters
Exit
About
Easy Search Utility