97D-Link DNS-323 User Manual
Section 3 - Configuration
Replacing or Adding a New Hard Drive
It is recommended that you back up your important les before replacing or adding a new hard drive to the DNS-
323.
Replacing a Hard Drive:
Please make sure the power is off before replacing a hard drive. After you install the new drive, turn on the DNS-323
and then connect to the Web UI. The DNS-323 will prompt you to format the new drive (Standard, RAID 1 mode) or
both drives (JBOD, RAID 0 mode).
Adding a New Hard Drive:
The DNS-323 is able to work with one single hard drive under Standard mode. Please make sure the power is off
before installing a second hard drive.
After you install the new drive, turn on the DNS-323 and then connect to the Web UI. The DNS-323 will prompt you
to format the new drive.
Note: Formatting a hard drive will erase the data stored on the hard drive. Please back up important data before
formatting a hard drive.
To Next Page
Loading...
