D-Link DNS-323

56D-Link DNS-323 User Manual
Section 3 - Configuration
Configure a new Hard Drive to RAID 1
When inserting a new hard drive into the DNS-323, you can congure it to RAID 1, which will mirror the existing hard
drive. By doing this, the new hard drive must have at least the same storage space as the existing hard drive.
To add a new hard drive and congure it to RAID 1
carry out the following steps:
Turn off the power and insert a new hard drive into 1.
an available drive bay. For more information on
Hardware Setup, refer to page 9.
Turn on the power and log in the web interface.2.
The page appears in order to congure the new 3.
hard drive.
Select the 4. Recongure to RAID 1 check box.
Click 5. Next to proceed.
A warning message appears. Click 6. OK to
proceed.