48D-Link DSL-124 Wireless N300 ADSL2+ Modem Router User Manual
Section 4 - Conguration
Idle Time(s): If you selected Connect on Demand, enter the amount time the
router waits if there is no activity before disconnecting.
Bridge: Select Bridged Ethernet (Transparent Bridging), Bridged
PPPoE(implies Bridged Ethernet), or Disable Bridge.
AC-Name: Used for PPPoE tagging, normally this should be left blank.
Service-Name: Used for PPPoE tagging, normally this should be left blank.
802.1q: Choose to either Disable or Enable the use of VLANs.
MTU(1-1500): Enter the packet size. The default is 1492.
Static IP: If you have been assigned a static IP by your ISP, enter it here.
Source Mac
address:
By default the DSL-124’s MAC address is listed. Press MACCLONE to
clone your configuring device’s MAC address.
Click Apply Changes to have your changes take effect. Click Return to discard your
changes and return to the Internet Setup page. Click Undo to revert back to the existing
settings.
Modify PPPoE Connection Additional Settings (continued)
Note: If you need to configure IPv6, you must configure it by using the Modify method
listed at the begining of this cheaper.
To Next Page
Loading...
