DSL-2740E User Manual
4
LAN4/3/2/1
For a PC or other Ethernet-abled device to join the LAN of
2740E by being connected to this interface with RJ-45
cable.
WPS
Press and hold the button for 3 seconds start WPS
negotiation.
WIRELESS
ON/OFF
Press and hold the button for 2 seconds start WLAN.
ON/OFF
Power switch, which is used to power on or power off the
host.
12V DC IN
(power)
Interface for connecting the power adapter.
Reset (On the
bottom side)
Press and hold the button for 4 seconds to restore the
factory defaults.
1.3 System Requirements
A 10 baseT/100BaseT Ethernet card installed on your PC
A hub or switch (attached to several PCs through one of Ethernet interfaces
on the device)
Operating system: Windows Vista, Windows 7, Windows 98SE, Windows
2000, Windows ME or Windows XP
Internet Explorer V5.0 or higher, Netscape V4.0 or higher, or Firefox 1.5 or
higher
1.4 Features
Various line modes
External PPPoE dial-up access
Internal PPPoE and PPPoA dial-up access
Leased line mode
1483B, 1483R, and MER access
Multiple PVCs (eight at most) and these PVCs can be isolated from each
other
A single PVC with multiple sessions
Multiple PVCs with multiple sessions
Binding of ports with PVCs
To Next Page
Loading...
Need help?
Data Transfer Rates
