DSL-2740E User Manual
89
3.3.13.5 NAT IP Mapping
Choose Advanced > NAT > NAT IP Mapping. The NAT IP Mapping page shown
in the following figure appears.
Entries in the Current NAT IP Mapping Table allow you to configure one IP pool
for a specified source IP address from LAN, so one packet whose source IP is in
range of the specified address will select one IP address from the pool for NAT.
3.4 Maintenance
3.4.1 System
Choose Maintenance > System. The page shown in the following figure appears.
In this page you can reboot your router or save your router configuration to a file on
your computer in case you have to reset your router to factory default settings. You
To Next Page
Loading...
Need help?
Data Transfer Rates
