DSL-2740E User Manual
87
3.3.13.3 NAT Forwarding
Choose Advanced > NAT > NAT Forwarding. The NAT Forwarding page shown
in the following figure appears.
Entries in this table allow you to automatically redirect common network services to
a specific machine behind the NAT firewall. These settings are only necessary if
you wish to host some sort of server like a web server or mail server on the private
local network behind your Gateway's NAT firewall.
Under 1483MER or 1483Routed mode, if NAPT (Network Address Port Translation)
is enabled, the Local IP Address is configured as 192.168.1.3 and the Remote IP
Address is configured as 202.32.0.2, the PC with the LAN IP192.168.1.3 will use
202.32.0.2 when it is connected to the Internet via the router without NAPT control.
The following table describes the parameters and buttons of this page:
Field Description
Local IP Address
Input a local IP address.
Remote IP
Address
Input a remote IP address
Enable Enable the current configured rule.
Apply Changes Submit the configurations.
Reset
Cancel the modification and reconfigure the
settings.
To Next Page
Loading...
Need help?
Data Transfer Rates
