27
Hotline Functions
FXS port: When the user picks up the phone, the gateway automatically dials your assigned
hotline number. When in hotline mode, other lines cannot be used.
Hot Line No.: Enter the hot line number for an automatic dialing function.
Warm Line: When the warm line function is in use, user can dial a number. Otherwise the
system will divert incoming calls from an outside line to the Hot Line Number after a set wait
time.
FXS Group: Select group hunting when there is an incoming call, the gateway will
automatically assign an unassigned call according to Hunting Priority. If Line 2 does not
want to be set as an assigned line to receive any inbound calls, the function can be disabled.
Users can also use the Up or Down key to adjust hunting priority.
Enable FAX: Enable this line to detect if there is a FAX tone to transfer the Codec.
Ring Time Limit(10 - 600secs)：The timeout to cancel a call when no one answers.
Enable End of Digit Tone：The gateway will play a “Beep-Beep” tone to notify the call is in
progress.
VoIP Calling Notification: The gateway will play a tone to notify the call is through VoIP.
Early Media Treatment: If it is disabled, the system will send RTP immediately when the
connection with Proxy is set up. The default is enabled. If communicating with other
Gateway has problem, please disable this function.
Hunting/Ring: It is able to set FXS group hunting using simultaneous ring or sequential ring.
Sequential Ring Time: To set the ring time of each port, when sequential ring is chosen.
To Next Page
Loading...
Need help?
General
