Need help?Do you have a question about the D-Link DVG-5008S and is the answer not in the manual?
General| Type | VoIP gateway |
|---|---|
| Ports | 8 FXS ports |
| Protocols | SIP, H.323 |
| Power Supply | AC 100-240V, 50/60Hz |
| Voice Codec | G.711, G.723.1, G.729A/B |
| Network Interface | 10/100 Mbps Ethernet |
| Management | Web-based |
Details the stand-alone VoIP Gateway's voice and facsimile capabilities over IP.
Details the indicators and ports on the front panel of the DVG-5008S.
Details the rear panel ports and connections of the DVG-5008S.
Describes the three basic modes for the network interface.
Explains settings for gateways with public IPs and within NAT networks.
Details configuration for IP sharing when using a public IP address.
Illustrates connecting phone sets/PBX and integrating with a PBX system.
Outlines prerequisites and basic IP/telephone number configurations for IVR setup.
Lists function codes for various settings and queries via IVR.
Details static IP, DHCP, and PPPoE configuration for the WAN port.
Provides steps for accessing and configuring the gateway via web browser.
Covers configuration of WAN/LAN ports, IP, and Phone Books Manager.
Configuration for PPTP, BigPond, and DNS server settings.
How to clone MAC and setup Phone Books Manager.
Settings for LAN interface mode and DHCP server configuration.
Configuration of Quality of Service for WAN and LAN traffic.
Settings for NAT traversal and various DDNS servers.
Settings for Caller ID display and anonymous calls on FXS ports.
Configuration of hotline, warm line, FXS group hunting, and FAX enable.
Configures outbound proxy, session timers, and P-Assert for SIP.
Configuration for E.164 numbering and call routing.
Configuration for interworking with SIP proxy servers and soft switches.
Registering FXS ports as a hunting group or independently to a proxy.
Settings for call forwarding, hold, transfer, and waiting features.
Settings for administrator login and DTMF timings.
Configuration of listening, speaking, tone volumes, flash time, and polarity for each line.
Configuration of audio codecs, jitter buffer, and silence suppression.
Configuration for fax transmission protocols (T.38, T.30) and quality.
Settings to drop inactive calls based on silence detection.
Setting up and querying phone numbers for gateway communication.
Configuration of speed dial numbers for quick dialing.
IP-based filtering for SIP invites and web management access.
Configuration to set up a CDR Server for call detail recording.
System language settings for web UI and IVR.
Adjustment of call progress tones and display of system status.
Displays information about the last finished call's RTP packets.
Inquires NAT type and performs ping tests for troubleshooting.
Configuration of SNMP and NTP for network management and time sync.
Procedures for backing up and restoring gateway configurations.
Configuration of Provision Server settings for automatic provisioning.
Operations for saving settings and restarting the gateway.
Procedures for upgrading the gateway's software.
Process for logging out of the gateway's interface.
Instructions for dialing and flowchart of dialed number processing.
Configuration of static routes and dynamic routes using RIP.
Filtering data by port range and limiting IP access to the Internet.
Filters data transmission based on MAC addresses.
Allows external access to internal services and exposes LAN servers directly.
Denies LAN access to specific websites by blocking URLs.
Provides multiple connections for special application configurations.
Settings to prevent DoS attacks and block malicious IPs.
To Next Page
