These settings are only necessary when the gateway is set up under a NAT that uses a dynamic IP
address and do not support DDNS.
Choose a DDNS Server: The current system allows users to choose either DynDNS、TZO、3322.org、
PeanutHull or a private server. Please apply for a user account before choosing a service provider.
Server address: Sets up the IP address or URL (Uniform Resource Locator) of the DDNS
Server.
Hostname: The URL of the system (or NAT) – apply from a domain name registration
providers.
Login ID and Password: The ID and password are used to log into the DDNS server.
Behind NAT: Select only when the system is set up under NAT.
Note: If the Gateway is set up under NAT, then enter the hostname into the NAT IP/Domain that is the
same with Hostname of DDNS.
Example:
NAT
DDNS
Telephony Settings
FXS Caller ID Generation: Select this option to enable the caller ID display function. When
enabled, the caller’s phone number will be displayed on your phone set when the call
comes through. FSK is preferred in some countries.
FSK Caller ID Type: Select FSK type. In most cases, Bellcore is preferred in North America
and ETSI in Europe.
Anonymous Caller ID (CLIR): When enabled, the caller’s phone set will not display your
number.
Note: If you register the gateway to a Proxy, you may be unable to make a call. This is due
to the fact that the gateway doesn’t send the number for authorization.
Enable: Enable a line; if some lines are not used, disable them (Pause Function) to avoid
unnecessary waiting when an incoming call is diverting to this line.
To Next Page
Loading...
Need help?
General
