DVG-7111S User’s Manual SETUP
D-Link Systems, Inc. 25
SETUP → VoIP Setup
Outbound Proxy Support: Check the box to send all SIP packets to the destined outbound proxy
server. An outbound proxy server handles SIP call signaling as a standard SIP proxy server would do.
Further, it receives and transmits phone conversation traffic (media) between two communication
parties. This option tells the VoIP TA to send and receive all SIP packets to the destined outbound
proxy server rather than the remote VoIP device. This helps VoIP calls to pass through any NAT
protected network without additional settings or techniques. Please make sure your VoIP Service
Provider supports outbound proxy services before you enable it.
Outbound Proxy IP/Domain: Enter the outbound proxy’s IP address or URL.
Outbound Proxy Port: Enter the outbound proxy’s listening port.
SETUP → VoIP Setup
Enable P-Assert: Check the box to enable the caller ID protection.
Privacy Type: It is used to disguise the caller ID when queried via an VoIP Service Provider/Third-Party
Assertion. The Privacy Type includes ‘user’, ‘header’, ‘session’, ‘none’, ‘critical’, ‘id’ and ‘history’.
SETUP → VoIP Setup
The rule of dialing of inviting to VoIP Service Providers may vary. That is, you have to configure
different Digit Map for different VoIP Service Providers. In this filed, you can configure individual dialing
plan for each VoIP Service Provider. The following examples introduce some cases. For general
configuration, refer to Digit Map page.
Note: Press “Add” to add an entry. Don’t forget to press “Apply” which in the above of Number
Translation.
To Next Page
Loading...
